Bosch WAP24200UC - Manual (Page 31)

31
Water cannot be seen
in the drum.
The water level in your high effi-
ciencey front load washer is below
the visible part of the drum, this is
normal.
No action needed.
Water has not drained
completely.
Suds may be excessive (usually
due to too much detergent or non-
HE detergent being used).
Use less detergent for future loads. Be sure to use
only high efficiency HE-detergents.
No spin is selected. In order to exit the cycle, set the cycle selector to
Spin/Drain or select a spin speed range, then press
the Start/Pause button.
Pump is blocked. Check and clean the drain pump, water drain hose
and/or the drain pipe.
Drain hose or drain pipe is blocked. Clean drainage pipe and/or drainage hose.
Water is coming out
from the underneath
the washer.
Water supply hose is leaking: is not
screwed on tight at both ends, or
rubber washer not placed in hose.
Eliminate the cause: tighten the hose (by hand at the
washer end), check for rubber washer in place.
Drain hose is leaking. Check the drain hose, be sure that it is on the washer
securely with the clamp in place; may need to replace
the drain hose if leaking continues.
Foam comes out of the
detergent dispenser
drawer.
The cyle status
sequence Wash flashes
in the display.
Too much detergent was used, or a
non-HE detergent was used; pump
was not able to pump out the
increased suds.
Immediate fix: mix 1 tablesponful of fabric softener
with 1/2 liter (1 pint) of water and pour this mixture
into the detergent compartment (not with waterproof
fabrics).
To prevent: use less detergent for future wash loads.
Repeated spinning. The Unbalanced Load Detection
system ia attempting to balance the
load through repeated spins.
To prevent: always load the washer with a mixture of
large and small wash items (easier to distribute in the
drum).
No spin took place
(laundry is still wet).
Load size to small. Add more laundry.
Large items may have become
entangled in the drum and could
not be distributed by the Unbal-
anced Load Detection system; spin
cycle therefore canceled for safety
reasons.
To prevent: always load the washer with a mixture of
large and small wash items (easier to distribute in the
drum).
Excessive suds: too much deter-
gent was used, or a non-HE deter-
gent was used.
Immediate fix: mix 1 tablesponful of fabric softener
with 1/2 liter (1 pint) of water and pour this mixture
into the detergent compartment (not with waterproof
fabrics).
To prevent: use less detergent for future wash loads.
Detergent residue on
the laundry.
Some phosphate-free detergents
contain water-insoluble residues
may appear as light spots on the
laundry.
Brush off when laundry is dry or
execute the program Rinse.
System shakes or
shudders when spin
speed increases.
The washer drum suspension sys-
tem shifts during spinning as the
speed increases. This may result in
a slight shaking of the washer
during the spin speed transition.
Mix small and large laundry items together in the load
to minimize this effect. Check to be sure the washer is
level and all four feet press equally against the floor.
Transport bolts removed?
~ Remove the transport bolts; Page 12
Problem Possible cause(s) Solution(s)