Bosch HGS7282UC - Manual (Page 7)

7
Flexible connector Method
Gas Shut-
Off Valve
Flexible
Connector
Regulator
1. Install male 1/2" (12.7 mm) flare adaptor at the 1/2"
(12.7 mm) NPT internal thread of the range inlet.
Use a backup wrench on the elbow fitting to avoid
damage.
2. Install male 1/2" (12.7 mm) or 3/4" (19 mm) flare
union adapter on the NPT internal thread of the
manual shutoff valve.
3. Connect flexible metal appliance connector.
, cautIon
Before you plug in an electrical cord, be sure all con-
trols are in the OFF position.
4. Make sure circuit breaker is off and then plug
range cord into electrical outlet.
5. Slide range into position ensuring that the left
back leg slides under the anti-tip bracket. Range
will sit 3/4" (19 mm) away from back wall when
properly installed.
notE: Be careful not to crimp flexible connector!
6. Carefully tip range forward pulling from the back
to ensure that the anti-tip bracket engages the
range leg and prevents tip-over.
rigid Pipe Method
gas shut off valve
elbow
nipple
nipple
nipple
union
elbow
1/2” to 3/4”
gas pipe
Gas Flow to Range
elbow:
connect to
regulator here
The configuration of the rigid pipe connection will
vary depending on the location of the gas pipe stub.
Refer to figure above for details.
, cautIon
Before you plug in an electrical cord, be sure all con-
trols are in the OFF position.
1. Make sure circuit breaker is off and then plug
range cord into electrical outlet.
2. Slide range into position ensuring that the left
back leg slides under the anti-tip bracket. Range
will sit 3/4" (19 mm) away from back wall when
properly installed.
3. Carefully tip range forward pulling from the back
to ensure that the anti-tip bracket engages the
range leg and prevents tip-over.
4. Connect pipe to range at union. Access the con-
nection through the access panel behind the
warming drawer.
notE: Be careful not to apply pressure to warming
drawer element during rigid pipe installation.