Bosch MUM6N10UC - Manual (Page 14)

14
Placing into Operation Dough Hook
Make sure that the power unit is on
a smooth, clean, suitable work surface and
switched to the Off position, “0/off”. Unwind
the electrical cord to the necessary length
and plug into a convenient outlet. The
mixing bowl with dough hook is now ready
for operation. See table 1 for examples
demonstrating the use of the dough hook
attachment. Sample recipes may also be
found in the recipe section, at the back of
this manual.
How to Use Twin Beating
Whisks
All Bosch Universal Kitchen Machines come
with a twin beating whisk assembly, see
figure 3b.
The twin beating whisks is intended to be
used for very light substances, such as
cream, egg whites, sauces, batters and
light pastry doughs that are thin enough to
pour.
The dough hook should be used for all
heavier substances such as cookie doughs,
yeast doughs, pastry doughs and other
heavy doughs. The dough hook should
always be used when adding nuts,
chocolate chips, dried fruits, hard butter or
other fats, hardened brown sugar, etc. to
a mixture.
Use of mixing bowl with twin beating
whisks
Before beginning to attach this or any other
attachment, make sure that the power unit
is on a smooth, clean, suitable surface and
switched to Off position, “0/off”, and that
you have moved the motor drive cover.
1. Before using the mixing bowl and twin
beating whisk assembly for the first
time, it is recommended that the bowl,
splash ring, cover and twin beating
whisk assembly be washed.
All components of the mixing bowl
and the twin beating whisk assembly
are dishwasher safe.
2. If you have not already done so, move
the motor drive cover to the high-
speed drive.
The power unit does not start if the
motor drive cover is not on its place.
3. Place the mixing bowl on the high-
torque drive of the power unit and turn
the bowl counterclockwise with
a slight downward pressure until bowl
is firmly seated, see figure 4a.
4. Place and engage the twin beating
whisk assembly on the driveshaft of
the mixing bowl as shown in figure 6.
Make sure that the toothed wheel
interlocks with the drive shaft.
Figure 6
ATTENTION
Failure to make sure that the bowl is
properly seated on the drive coupling
before the power unit is turned On can
result in damage to the bowl and/or
coupling.