Bosch SGE63E15UC - Manual (Page 12)

11
LEVELING THE DISHWASHER
SECURING THE DISHWASHER
For Top Mount - Wooden
For Side Mount - Stone Countertop
Avoid Tip Over Hazard
Do not use the dishwasher until it is completely
installed. When opening the door on an uninstalled
dishwasher, carefully open the door while supporting
the rear of the unit. Failure to follow this warning
can result in serious injury.
WARNING
Figure 17
Figure 18
Figure 19
1. Drive the mounting screws through the holes in the
mounting brackets as shown for Top (Figure 18), Side
Mount (Figure 19) and Alternate Side Mount (Figure 20).
2. After the unit is installed in the enclosure, leveled and
secured, lock the two front leg levelers in place by driving
the enclosed leg leveler locking screws into each screw
boss located in front of the levelers.
3. Tighten screws until they are flush with the surface of the
bosses.
The unit should now be ready to slide into the cabinet
opening. To avoid scratching the floor, use floor protection
and caution when sliding the dishwasher into the cabinet.
Make sure that the hoses and cords do not bunch up behind
the unit or kink as you slide the unit back. Make certain to
slide the unit into place before raising the leg levelers.
Level the dishwasher horizontally by turning feet clockwise
to raise or counter-clockwise to lower front of the unit.
Level the dishwasher vertically by turning center screw to
raise or lower the back.
For Alternate Side Mount
Figure 20
N
1 / 16 ″ (2mm)
~ 1
/ 2
″ (12mm)
D
1
/ 16
″ (2mm)
~ 1 / 2 ″ (12mm)
D