Autostart CT-5000 - Manual (Page 18)

P.18 Installation Guide CT-5000
Disarmed Notification
This feature will notify the user when the vehicle is left disarmed after Ignition is turned off, or
when the Module is disarmed after being previously armed, the opening or closing of a Door
will cause the Horn or the Siren to sound once after 10 sec. to warn the user that the vehicle
was left unprotected. Pressing
LOCK or UNLOCK will cancel this timer.
Two-Stage Disarm
When the Siren is sounding, pressing UNLOCK will stop the siren – but without unlocking or
disarming the vehicle. You can disable this feature by selecting corresponding option in the
Passive or Active Function.
Shock Sense Bypass
When AUX 3 is programmed for Trunk with Disarm/Rearm option, and the Trunk pin from the
vehicle has been connected to the Door Pin input wire (diode isolated), it is not necessary to
press on
UNLOCK to disarm the Alarm prior to pressing the TRUNK button.
When the Trunk is opened by remote control, the Door Zone/“Trunk pin” will be ignored; the
Shock Sensor will also be ignored until the Door Zone/”Trunk pin” closes. Monitoring will
resume 5 seconds after the Door Zone (Trunk pin) is closed.
Resetting The Module
The Remote Car Starter is equipped with a reset function that allows the installer to erase all
Transmitter codes from memory and return all the Programming Options to the factory default
values. Resetting the Remote Car Starter is not a required process. Most of the time, you
can avoid resetting by fixing the issue directly at the root of the cause.
1. Flash the Hood Pin switch (see Table 1)
– Once inside Programming Mode, you have 10 seconds to complete the next step.
2. Press and release the Break Pedal 6 times (within 10 seconds from entering Programming
Mode).
3. The Parking Lights will flash 8 times to confirm resetting.
Table 12
On some vehicles (such as BMW and certain Volkswagen vehicles), resetting will not work if
the Brake Pedal is pressed while the Ignition Key is not in the
IGNITION ON (RUN) position: you
will need therefore to hot-wire the Brake Pedal by manually jumping 12 V with a fused test
lead at the Brake Pedal switch.
1. Flash the Hood Pin switch (see Table 1)
– Once inside Programming Mode, you have 10 seconds to complete the next step.
2. Press and release the Valet Button 6 times or more until the Parking Lights start to flash.
3. The Parking Lights will flash 8 times to confirm resetting.
Table 13
Events Logging
The Module will play back the last 4 Start Failure Events Codes and the last Intrusion Code
via the Parking Lights and L.E.D.
Events playback
Ensure that the Hood is up and that the Ignition is OFF .
• Hold down the Hood Pin-switch for 4 seconds.
• Release the Pin-switch.
• The Parking Lights will come on.
• With the Parking Lights on, immediately push the Pin-switch 3 times.