beautypg.com

Horn honk / siren timing (optional), Auto tach programming procedure, P.13 – Autostart CT-5000 User Manual

Page 13

background image

CT-5000 Installation Guide P.13

OPTION 2*

Shock Sense - monitored / Warn Away – monitored

OPTION 3

Shock Sense - Monitored / Warn Away – ignored

OPTION 4

Shock Sense - Ignored / Warn Away – monitored

Function 5 –

et

Ignition Val

OPTION 1

Ignition Valet - DISABLED

OPTION 2*

Ignition Valet - ENABLED

OPTION 3

Ignition Valet - ENABLED

Horn Honk / Siren Timing (Optional)

1. FLASH the Hood Pin Switch
Before the 20 seconds have passed,
2. Press and hold the Brake Pedal.

• Press the

START/STOP

and

UNLOCK

buttons simultaneously on the Transmitter.

• The Horn/Siren will sound 5 times.

3. Release the Brake Pedal.
4. To change the timing:
a. To increase the Horn Honk/Siren by 3 ms, press the

LOCK

button.

b. To increase the Pulse by 10 ms, press the

START/STOP

c. To decrease the Pulse by 3 ms, press the

UNLOCK

button.

d. To decrease the Pulse by 10 ms, press the

TRUNK

button.

5. To save the setting: press

LOCK

and

UNLOCK

. If 3 Honks/Chirps are heard the new value

has been saved.
For each timing change, the Horn/Siren will sound with the new setting, except

und

ircumstances:

er the following c

• When the lower limit of 5 ms is reached, the Horn/Siren will sound for 1/4 second.

• When the upper limit of 200 ms is reached, the Horn/Siren will sound for

3/4

second.

A system reset will set the system back to the default: 30 ms
Close the Hood to cancel the changes.

Auto Tach Programming Procedu

Table 4

re

NOTE:
If no tach has been programmed and the

START/STOP

button is pressed, there will be no start attempt and the
vehicle will give 5 flashes.
If another Tach Programming is required, simply
repeat the Auto Tach Programming Procedures.
The Module stores the Tach setting, being Auto Tach
or conventional Tach, until the Module is reset.
This process can be carried out instead of the conventional Tach Programming Procedure.

1. Make sure all the connections are done properly and that the Module has been

powered-up.

2. With the Hood up (Ground on the Hood Pin line), start the vehicle using the key.
3.

reach proper idle speed

Let the Engine

The Parking Light output from the Module is activated when the vehicle starts and it
will shut off once the Tach signal is detected.
4. Press and hold the Brake Pedal until the Parking Light output from the Module

flashes 5 times.

5. Turn the Ignition

OFF

. At this point, the Tach setting has been programmed.