Ampro Corporation 420 - Manual (Page 60)

Chapter 4 BIOS Setup
54 Reference Manual CoreModule 420
♦ Assign DMA 2 – [Disabled] or [Enabled]
∗ If this field is set to [Enabled], then the BIOS can assign this DMA channel to a Plug and
Play adapter.
∗ If another device in the system is using this DMA channel, then this field should be set to
[Disabled].
♦ Assign DMA 3 – [Disabled] or [Enabled]
∗ If this field is set to [Enabled], then the BIOS can assign this DMA channel to a Plug and
Play adapter.
∗ If another device in the system is using this DMA channel, then this field should be set to
[Disabled].
♦ Assign DMA 5 – [Disabled] or [Enabled]
∗ If this field is set to [Enabled], then the BIOS can assign this DMA channel to a Plug and
Play adapter.
∗ If another device in the system is using this DMA channel, then this field should be set to
[Disabled].
♦ Assign DMA 6 – [Disabled] or [Enabled]
∗ If this field is set to [Enabled], then the BIOS can assign this DMA channel to a Plug and
Play adapter.
∗ If another device in the system is using this DMA channel, then this field should be set to
[Disabled].
♦ Assign DMA 7 – [Disabled] or [Enabled]
∗ If this field is set to [Enabled], then the BIOS can assign this DMA channel to a Plug and
Play adapter.
∗ If another device in the system is using this DMA channel, then this field should be set to
[Disabled].