Electrolux EI30DD10KS - Manual (Page 17)

17 Solutions to Common Problems
Questions or for service call: 1-877-4ELECTR OLUX (1-877-435-3287)
Before you call
Problem Solution
Telescoping Vent
does not fully
raise
- Check for and remove obstructions. The telescoping vent is designed to tilt and
stop with obstructions. The raise/lower push button will reverse direction of travel
and reset the telescoping vent travel. Allow the telescoping vent to fully raise or
lower after encountering an obstruction.
- If the telescoping vent does not response to the raise/lower push button, it can be
straightened or helped along by hand and the switch should be tried again.
- DO NOT attempt to lubricate the telescoping vent. It is factory lubricated for life.
Blower does not
turn on
- Make sure telescoping vent is in the upper most position.
- Make sure the blower slide adjustment is not in the off position.
- If used for an extended period of time, allow the blower to cool. The blower is
thermally protected and will shut off until cooled sufficiently. It will resume normal
operation when cool.