Installation, Remove control box cover – Electrolux EI30DD10KS User Manual
Page 12

12
Remove Control Box Cover
Remove the cover to the Control Box by removing
the Phillips screw as shown and sliding the cover
down.
Remote Blower Wire Connection
Make Blower Electrical Connection
and Install Remote Blower
- Depending on the type of blower you purchased,
refer to its documentation for proper installation
instructions.
- Push wires into wire compartment.
- Re-install the control box cover, do not pinch wires
when re-installing the cover.
NOTE
If you purchased Internal Blower Kit EI06DDPIKS
refer to the installation manual provided with the kit
for proper installation instructions for this blower
NOTE
The wire nuts supplied with the unit are made for
14 AWG wire. The installer must supply correct wire
nuts if a different wire size is used.
Installation
Phillips
Screw
Control Box Cover
Downdraft Vent Control Box Blower Wire Connection
Ground
Neutral
Line
Ground (Green)
Line (Black)
Neutral (White)
Control Box
Wire
Nuts (3)
Blower Motor
Wiring (Romex
or conduit)
Terminal
Block
Ground
(Green/Bare)
Neutral
(White)
Line
(Black)
Romex Cable or
Wiring in
Metal Conduit
Romex
Clamp
Specific to the EI16DDPRKS model