Installation, Important, Install ductwork install cooktop – Electrolux EI30DD10KS User Manual
Page 13: Connect downdraft to power

13
Install Ductwork
Install Cooktop
- Align the cooktop with the downdraft and fasten
cooktop in place.
Connect Downdraft to Power
- Plug the downdraft’s power cord into the outlet.
- Make sure the power cord is routed beneath the
appliance and away from heat generated by the
cooktop.
IMPORTANT
All ductworks must be as installed as per local codes.
NOTE
NOTE
Accurate alignment of cooktop and downdraft is
necessary to ensure that there is no interference
when air vent is raised and lowered. There should
be a gap of 1/8” between the back of the cooktop
and the front of the downdraft cover.
Local building codes must be followed in specifying
approved type and specifications of ALL duct used.
Always use an appropriate roof or wall cap with damper.
Screw
Air Flow
Duct Tape Over Seam and Screw
Installation
Re-attach Transition Duct
The Transition Base must be installed with the flange
at the top. Position the duct Transition Cover on the
Transition Base for the discharge direction selected.
The top edge of the duct Transition Cover must be
under the tabs of the Transition Base.
Down Discharge – Attach the transition with 4 screws
as shown.
Connect the ductwork
- Use galvanized or aluminum duct in 8” or 10” round
or 3 ¼” x 14” size, or a combination of both. PVC
duct should be used if installing under a poured
concrete slab. Use the shortest and straightest duct
run possible.
Transition
Base
Remove Phillips
Head Screw
from Left Hole
and Reattach as
Shown
Duct Transition
Cover
(4) Phillips
Head Screws
(4) Phillips
Head
Screws
(4) Phillips
Head Screws
Remove Phillips
Head Screw from
Right Hole and Attach
as Shown
Discharge Down (as supplied)
Discharge Left
Discharge Right
Discharge
Discharge
Left or Right Discharge – Remove the Phillips head
screw from the chassis. Attach the transition with 5
screws as shown.