American Dryer Corp. MLG-460 - Manual (Page 85)

81
• The Proximity Sensor is located in the same area as the Tumbler Junction Box
• Inductive Proximity Mechanical Adjustment
• The target that is attached to the outside of the tumbler (basket).
• Stop motion detector module.
• Circuit wiring; refer to the Main Panel Wiring Diagram, Tumbler Junction Box Wiring Diagram
2b) If the L.E.D. (light emitting diode) is constantly “ON”
• If yes, the stop motion detector is defective.
• If no, check:
• Inductive Proximity Sensor for damage. The proximity sensor is located in the same area as
the Tumbler Junction Box.
• Inductive Proximity Mechanical Adjustment.
• Tumbler (basket) target.
- This target is attached to the outside of the tumbler (basket).
• Stop motion detector module in the tumbler (basket) section on the left front side.
• Circuit Wiring; refer to the Main Panel Wiring Diagram.
• Tumbler Junction Box Wiring Diagram.