American Dryer Corp. MLG-460 - Manual (Page 77)

73
• If the de-energizing time is incorrect:
• Adjust the “time adjust” on the stop motion detector module and retest.
If the input #0, 10 on the PLC (Programmable Logic Controller) is not on after several rotations
of the tumbler (basket):
• Check fuse #2 and replace if necessary.
• Rotate the tumbler (basket) using the pendant control in ”LOAD POSITION.” Does the
module’s L.E.D. (light emitting diode) respond?
• If yes, adjust the “sense time” until the L.E.D. (light emitting diode) stays on for 12 to 15
seconds after the tumbler (basket) stops, then refer to Section 7a on page 72.
• If no, check:
• Inductive proximity sensor for damage.
• Sensor distance from targets is 3/16”. The proximity sensor is located in the same area as
the tumbler junction box.
• Inductive proximity adjustment.
• Tumbler (basket) target.
• Stop motion detector module.
• Circuit wiring;
Refer to the dryer’s Main Panel Wiring Diagram, dryer’s Tumbler Junction Box Wiring
Diagram.