Users in the u.s.a, Users in canada – Canon imageCLASS MF6160dw User Manual

Page 20

Users in the U.S.A.

Pre-Installation Requirements for Canon Facsimile Equipment

A. Location
Supply a suitable table, cabinet, or desk for the machine. See the

e-Manual for specifi c dimensions and weight.

B. Order Information
1. A single telephone line (touch-tone or rotary) should be used.
2. Order an RJ11-C telephone wall jack (USOC), which should be

installed by the telephone company. If the RJ11-C wall jack is not

present, telephone/facsimile operation is not possible.

3. Order a normal business line from your telephone company’s

business representative. The line should be a regular voice grade

line or an equivalent one. Use one line per unit.

DDD (Direct Distance Dial) line
-or-
IDDD (International Direct Distance Dial) line if you communicate

overseas

NOTE
Canon recommends an individual line following industry standards,

i.e., 2,500 (touch-tone) or 500 (rotary/pulse dial) telephones. A

dedicated extension oﬀ a PBX (Private Branch eXchange) unit

without “Call Waiting” can be used with your facsimile unit. Key

telephone systems are not recommended because they send

nonstandard signals to individual telephones for ringing and special

codes, which may cause a facsimile error.

C. Power Requirements
The machine should be connected to a standard 120 volt AC,

threewire grounded outlet only.
Do not connect this machine to an outlet or power line shared with

other appliances that cause “electrical noise.” Air conditioners,

electric typewriters, copiers, and machines of this sort generate

electrical noise that often interferes with communications equipment

and the sending and receiving of documents.

Connection of the Equipment
This equipment complies with Part 68 of the FCC rules and the

requirements adopted by the ACTA. On the rear panel of this

equipment is a label that contains, among other information, a

product identifi er in the format of US:AAAEQ##TXXXX. If requested,

this number must be provided to the telephone company.
The REN (Ringer Equivalence Number) is used to determine the

number of devices that may be connected to a telephone line.

Excessive RENs on a telephone line may result in the devices not

ringing in response to an incoming call. In most, but not all areas, the

sum of the RENs should not exceed fi ve (5.0).
To be certain of the number of devices that may be connected to a

line, as determined by the total RENs, contact the local telephone

company. The REN for this product is part of the product identifi er

that has the format US: AAAEQ##TXXXX. The digits represented by

## are the REN without a decimal point (e.g., 10 is a REN of 1.0).
An FCC compliant telephone line cable and modular plug is provided

with this equipment. This equipment is designed to be connected to

the telephone network or premise wiring using a compatible modular

jack that is Part 68 compliant.
This equipment may not be used on coin service provided by the

telephone company. Connection to party lines is subjected to state

tariﬀ s.

In Case of Equipment Malfunction
Should any malfunction occur which cannot be corrected by the

procedures described in this guide or the e-Manual, disconnect the

equipment from the telephone line cable and disconnect the power

cord.
The telephone line cable should not be reconnected or the power

switch turned ON until the problem is completely resolved. Users

should contact Canon Authorized Service Facilities for servicing

of equipment, Information regarding Authorized Service Facility

locations can be obtained by calling Canon Customer Care Center

(1-800-OK-CANON).

Rights of the Telephone Company
If this equipment (imageCLASS MF6180dw/MF6160dw) causes

harm to the telephone network, the telephone company may

temporarily disconnect service. The telephone company also retains

the right to make changes in facilities and services that may aﬀ ect

the operation of this equipment. When such changes are necessary,

the telephone company is required to give adequate prior notice to

the user.
However, if advance notice is not possible, the telephone company

will notify the customer as soon as possible. Also, the customer will

be advised of his/her right to fi le a complaint with the FCC if he/she

believes it is necessary.

WARNING

The Telephone Consumer Protection Act of 1991 makes it unlawful

for any person to use a computer or other electronic device, including

FAX machines, to send any message unless such message clearly

contains in a margin at the top or bottom of each transmitted page or

on the fi rst page of the transmission, the date and time it is sent and

an identifi cation of the business or other entity, or other individual

sending the message and the telephone number of the sending

machine or such business, other entity, or individual. (The telephone

number provided may not be a 900 number or any other number for

which charges exceed local or long-distance transmission charges.)

NOTE
In order to program this information into your machine, you should

complete the procedure for registering your name, unit’s telephone

number, time, and date in the Getting Started.

Users in Canada