Regular printing is selected, but a roll is loaded, Paper jam, Paper is crooked – Canon imagePROGRAF iPF760 User Manual
Page 114
Cause
Corrective Action
You have attempted to print a test print sheet or other
printer status information on a sheet, but no sheet is
loaded.
(See "Loading and Printing on Rolls.")
→User's Guide
Regular printing is selected, but a roll is loaded.
Regular printing is selected, but a roll is loaded.
Cause
Corrective Action
A print job for printing on
sheets was sent when a
roll is loaded.
1.
Press ▲ or ▼ to select Remove Roll Paper, and then press the OK button to stop printing.
2.
After removing the roll, load and print on a sheet of the type and size of paper you have specified in the
printer driver.
(See "Removing the Roll from the Printer.")
(See "Loading and Printing on Sheets.")
→User's Guide
Paper jam
Paper jam
"Push the release lever back."
Cause
Corrective Action
A paper jam occur-
red in the printer
during printing.
1.
Push the Release Lever back and remove the jammed paper.
(See "Clearing Jammed Roll Paper.")
(See "Clearing a Jammed Sheet.")
2.
Load the paper.
3.
Pull the Release Lever forward.
4.
If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press the OK
button.
Printing will resume, starting from the page on which the error occurred.
(See "Loading Rolls in the Printer.")
(See "Loading Sheets in the Printer.")
"Manually rewind the roll all the way and press OK."
Cause
Corrective Action
A paper jam occurred
when advancing the
paper.
1.
Rewind paper on the Roll Holder manually, all the way, and then press the OK button.
2.
Load the paper.
3.
If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press the OK
button.
Printing will resume, starting from the page on which the error occurred.
(See "Loading Rolls in the Printer.")
Paper is crooked.
Paper is crooked.
Cause
Corrective Action
Paper loaded crooked was detected when the paper was advanced.
Follow these steps to reload the roll.
1.
Push the Release Lever back.
2.
Adjust the right edge of the roll to make it parallel to the orange
Paper Alignment Line.
3.
Pull the Release Lever forward.
(See "Loading Rolls in the Printer.")
Regular printing is selected, but a roll is loaded.
iPF760
Error Message
Messages regarding paper
114