Canon RC-V100 - Manual (Page 16)

16
Customization
You can personalize various aspects of the remote controller’s operation, including the
brightness of buttons and indicators and the dials’ direction, to your preference.
* PAINT-group dials: KNEE POINT dial, KNEE SLOPE dial, BLACK GAMMA LEVEL dial, SHARPNESS
LEVEL dial.
** WB/MB group dials: WHITE BALANCE R dial, WHITE BALANCE B dial, MASTER BLACK R dial, MASTER
BLACK B dial.
Micro
switch
Category Content
Micro Switch Position
ON OFF
A-1 Dials’ Direction PAINT-group* dials’ direction Reverse Normal
A-2 WB/MB-group** dials’ direction Reverse Normal
A-3 ZOOM dial direction Reverse Normal
A-4 FOCUS dial direction Reverse Normal
A-5 MASTER PEDESTAL dial direction Reverse Normal
A-6 IRIS dial direction Reverse Normal
A-7 Dials’ Sensitivity IRIS dial sensitivity Low High
A-8 FOCUS dial sensitivity Low High
B-1 All other dials’ sensitivity Low High
B-2 Dials’ Mode PAINT-group* dials’ mode Absolute Relative
B-3 WB/MB-group** dials’ mode Absolute Relative
B-4 MASTER PEDESTAL dial mode Absolute Relative
B-5 Buttons/Indicators Lamps active Off On
B-6 Brightness Dim Bright
B-7 Sound Operating sounds Off On
B-8 Reserved for service/maintenance — —
About the dial modes
You can set the various dials’ mode to absolute or relative.
In relative mode, the value is adjusted according to the difference between the dial’s
position before the change and its position after the change. In relative mode, the
position of the dial does not reflect the current value of the setting being adjusted.
In absolute mode, the position of the dial always corresponds to the current value of
the setting being adjusted. The dial’s center position (where it clicks) represents the
setting’s standard value and the dial’s end positions correspond to the setting’s
maximum and minimum values.
NOTES
• When a dial is set to relative mode, the adjustment range may be narrowed
depending on the initial position of the dial when it was activated.
COP
Y