American Standard Cadet w/ Integral Apron Whirlpool and Bathing Pool 2776.218W - Manual (Page 2)

H66
© 2008 AS America Inc.
CADET™ 5' x 32" w/INTEGRAL APRON
WHIRLPOOL AND BATHING POOL
HIGH GLOSS
Revised 2/08
19-3/4
(502mm)
7/8 WATER
RETENTION
FLANGE
(3 SIDES)
20
(508mm)
1-1/2 O.D.TAILPIECE
BATH
SUPPORT
MATERIAL
ROUGH
FLOOR
FINISHED
WALL
TOP OF
DECK
59-7/8
(1521mm)
32
(813mm)
WATER
RETENTION
FLANGE
(3 SIDES)
7-3/4
(197mm)
12
(305mm)
2-3/8
(60mm) (8) JETS
2-3/4
(70mm)
CUTOUT IN FLOOR
FOR DRAIN PUMP
FINISHED
WALL
OPTIONAL TO
FINISHED FLOOR
USUALLY BETWEEN
65 & 78
(1651 & 1981mm)
C/L OF
OVERFLOW
C/L OF
SPOUT
C/L OF
VALVES
C/L OF
SHOWER ARM
2-3/4
(70mm)
4-5/8
(117mm)
1-1/2 N.P.T.M.
THREADS
3/4
(19mm)
9
(229 mm)
C/L OF
SUPPLIES
C/L OF DRAIN
SEE FITTING
SPECS FOR
DIMENSIONS
(2) AIR VALVES
ON/OFF
SWITCH
ACCESS TO PUMP/MOTOR
THROUGH REMOVABLE
FRONT ACCESS PANEL
UNDERSIDE
OF DECK
14-3/4
(375mm)
LEVELING
STRINGER
NOT FOR
SUPPORT
TILING
FLANGE
12
(305mm)
OPT.
4
(102mm)
14-3/4
(375mm)
WATER
RETENTION
FLANGE
(3 SIDES)
UNDERSIDE
OF DECK
19-3/4
(502mm)
7/8 WATER
RETENTION
FLANGE
(3 SIDES)
20
(508mm)
1-1/2 O.D.TAILPIECE
BATH
SUPPORT
MATERIAL
LEVELING STRINGER
NOT FOR SUPPORT
ROUGH
FLOOR
TOP OF
DECK
59-7/8
(1521mm)
32
(813mm)
7-3/4
(197mm)
12
(305mm)
2-3/8
(60mm)
2-3/4
(70mm)
CUTOUT IN FLOOR
FOR DRAIN
FINISHED
WALL
12
(305mm) OPT.
OPTIONAL TO
FINISHED FLOOR
USUALLY BETWEEN
65 & 78
(1651 & 1981mm)
C/L OF
OVERFLOW
4
(102 mm)
C/L OF
SPOUT
C/L OF
VALVES
C/L OF
SHOWER ARM
2-3/4
(70mm)
4-5/8
(117mm)
1-1/2 N.P.T.M.
THREADS
3/4
(19mm)
9
(229 mm)
C/L OF
SUPPLIES
C/L OF DRAIN
SEE FITTING
SPECS FOR
DIMENSIONS
FINISHED
WALL
SYSTEM I PUMP
GENERAL SPECIFICATIONS FOR 2776 WHIRLPOOL
WHIRLPOOL ELECTRICAL SPECIFICATIONS
1.25 HP, 9.9 AMPS,120V.
59-7/8 x 32 x 20 (1521 x 813 x 508mm)
115 Lbs. (52 Kg.)
574 Lbs. (258 Kg.)
55 Gal. (208 L.)
45 Gal. (171 L.)
20 x 40 (508 x 1016mm)
26 x 53-1/2 (660 x 1359mm)
14-1/2 (368mm)
43 Lbs./Sq.Ft. (208 Kgs./Sq.m)
20.8
35.3
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
WHIRLPOOL MIN. OPERATING VOL.
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
CUBE (FT3)
GENERAL SPECIFICATIONS FOR 2776 BATHING POOL
59-7/8 x 32 x 20 (1521 x 813 x 508mm)
75 Lbs. (34 Kg.)
525 Lbs. (236 Kg.)
54 Gal. (205 L.)
20 x 40 (508 x 1016mm)
26 x 53-1/2 (660 x 1359mm)
14-1/2 (368mm)
39 Lbs./Sq.Ft. (191 Kgs./Sq.m)
20.8
35.3
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
CUBE (FT3)
NOTES:
BATH TO BE INSTALLED ABOVE FLOOR LINE AS A RECESS INSTALLATION. SUPPORT OF BATH BY SUMP BEDDING. SUPPORT AND
ENCLOSING MATERIAL BY OTHERS.
■ REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL INFORMATION.
LEFT HAND OUTLET SHOWN, RIGHT HAND REVERSE DIMENSIONS (2776.118).
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL SUPPORTS.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standards Z124.1 and
A112.19.7. These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages.