Asante Technologies 7000 - Manual (Page 14)

Installation
Page 2-2
Components
This section describes the front- and back-panel layouts of the FS7108 and
FS7016 Switches.
The only control on the front panel is the uplink push-button switch. The only
control on the rear panel is the power switch. The LED indicators are described
in detail in Chapter 3.
The uplink push-button switch is connected to a single port on each Switch. In
Normal position, the port associated with the uplink switch operates like any
other port on the unit. When the uplink push-button is in the depressed
position, the port associated with the uplink switch becomes an uplink port and
eliminates the need for a crossover cable.
FS7108
The front panel of the FS7108 contains eight 10/100Mbps ports, one Gigabit
Ethernet port, one uplink switch button, and LED indicators. See Figure 2-1.
Figure 2-1 FS7108 front panel
The back panel of the FS7108 contains a 100–240 volt AC power connector, a
power switch, and an MII slot. See Figure 2-2.
Figure 2-2 FS7108 back panel
FriendlyNET 7108 Gigabit Switch
100/10Mbps
Full/Half
Link/Data Power 1 2 3 4 5 6 7 8 8 7 6 5 4 3 2 1 MII Power
Uplink
Normal Uplink
Switched Gigabit Ethernet Port
Link/Data
Full Duplex/Collision Power
Tx Rx
Uplink Switch Button
Eight 10/100 Ports LEDs
On
Off
100–240 Vac Input
MII Module
Power Connector
MII Slot Power Switch