Brother FS-20 - Manual (Page 81)

79
4
———————————————————————————————————————————————————————————————————————————————————————————————————————————————————————
g
Insert the bobbin case so that the S mark on
the bobbin case aligns with the z mark on
machine as shown below.
• Align the S and z marks.
a S mark
b z mark
c Bobbin case
• Make sure that the indicated points are
aligned before installing the bobbin case.
h
As shown, insert the tab on the needle plate
cover into the hole in the needle plate, and
then correctly position of the needle plate
cover.
a Needle plate cover
b Tab
c Hole
• Check that the needle plate cover is flush
with the top surface of the machine.
● Never use a bobbin case that is scratched,
otherwise the upper thread may become
tangled, the needle may break or sewing
performance may suffer. For a new bobbin
case (part code: XE7560-001), contact your
nearest authorized service center.
● Make sure that you fit the bobbin case
properly, otherwise the needle may break.
CAUTION