Brother FS-20 - Manual (Page 55)

53
3
———————————————————————————————————————————————————————————————————————————————————————————————————————————————————————
f
Position the fabric with the front end of the
buttonhole mark aligned with the red marks
on the sides of the buttonhole foot, and then
lower the presser foot lever.
a Mark on fabric
b Red marks on buttonhole foot
• When lowering the presser foot, do not push
in the front of the presser foot, otherwise the
buttonhole will not be sewn with the correct
size.
a Do not reduce the gap.
g
Pull down the buttonhole lever as far as
possible.
a Buttonhole lever
The buttonhole lever is positioned behind the
bracket on the buttonhole foot.
a Buttonhole lever
b Bracket
h
Gently hold the end of the upper thread in
your left hand, and then start sewing.
Note
● If thick seams are being sewn and the fabric
does not feed, sew with the coarser (longer)
stitch.
X
Once sewing is completed, the
machine automatically sews
reinforcement stitches, then stops.
i
Raise the needle and the presser foot lever,
remove the fabric, and cut the thread.
j
Raise the buttonhole lever to its original
position.
A
1
2
2