Caution – Brother PS-53 55 57 User Manual
Page 47
35
(Model STAR 240E, STAR 230E)
4. Slide the sewing speed controller to its maximum (as far to the
right as possible).
5. Push the Start/Stop button. The machine will stop automatically
when the bobbin is full.
6. After the bobbin has stopped moving, push the Start/Stop button
to stop the machine.
1
Sewing speed controller
CAUTION
When removing the bobbin, do not pull on the bobbin winder
seat. Doing so could loosen or remove the bobbin winder seat,
resulting in damage to the machine.
7. Cut the thread, slide the bobbin winder shaft to the left and
remove the bobbin.
(Mode PS-57, PS-55, PS-53)
4. Step down on the foot controller to start.
5. After the machine stops automatically when the bobbin is full,
take your foot off of the foot controller.
CAUTION
When removing the bobbin, do not pull on the bobbin winder
seat. Doing so could loosen or remove the bobbin winder seat,
resulting in damage to the machine.
6. Cut the thread, slide the bobbin winder shaft to the left and
remove the bobbin.
NOTE:
The needle bar does not move when the bobbin winding shaft is slid
to the right.
Immediately after winding the bobbin, it is normal to hear the sound
of the clutch engaging when beginning to sew or manually turning
the balance wheel.
CAUTION
Be sure to follow the process described. If the thread is not
cut completely, and the bobbin is wound, when the thread
runs low it may tangle around the bobbin and cause the
needle to break.
CAUTION
Setting the bobbin improperly may cause the thread ten-
sion to loosen, breaking the needle and resulting in injury.
1
Wound evenly
2
Wound poorly
1
2
(Model STAR 240E, STAR 230E)
(Model PS-57, PS-55, PS-53)
1