Brother CS 80 - Manual (Page 24)

GETTING READY ————————————————————————————————————————————————————————
18
Upper Threading
In this section, the procedures for positioning the spool for the upper thread and threading the needle are
described.
About the spool of thread
With this sewing machine, a spool of thread can be
loaded into the enclosed thread cassette, and then
the thread cassette can be threaded. Information
about the spools of thread is described below.
■ Spools that can be loaded into the thread
cassette
Normally, a spool of thread is loaded into the
thread cassette and used. The spools that can be
loaded must have a diameter smaller than the
orange spool cap and a height shorter than the
mark on the cover of the thread cassette.
1 Spool cap (orange)
2 Spool
3 Mark on thread cassette compartment cover
■ Spools that cannot be loaded into the thread
cassette
When using spools that cannot be loaded into the
thread cassette, use the enclosed extra spool pin.
When using the extra spool pin, attach either the
large or small white spool cap, depending on the
size of the spool. Use the spool cap with a diameter
that is slightly larger than the diameter of the spool.
1 Spool cap (large)
2 Spool cap (small)
3 Spool
Memo
● For details on using the extra spool pin,
refer to “ Using the extra spool pin”
(page 24).
● When using a spool of cross-wound thread,
install the small white spool cap with some
space between the cap and the spool.
1 Spool cap (small)
2 Gap
3 Spool
● When threading the upper thread, carefully follow the instructions. If the upper threading is
not correct, the thread may become tangled or the needle may bend or break.
CAUTION
1 1
1
2
3
1
2
3
1
3
2
S2_brotherE.book Page 18 Thursday, February 13, 2003 11:03 AM