Brother CS 80 - Manual (Page 18)

GETTING READY ————————————————————————————————————————————————————————
12
Winding/Installing the Bobbin
This section describes how to wind the thread onto the bobbin, and then insert the bobbin thread.
Bobbin precautions
Be sure to observe the following precautions concerning the bobbin.
Winding the bobbin
Wind the thread around the bobbin to prepare the bobbin thread.
1
Turn on the sewing machine.
2
Open the bobbin winder cover at the top on
the right side of the sewing machine.
3
Swing up the bobbin thread spool pin.
Move the bobbin thread spool pin up as far as
possible.
1 Bobbin thread spool pin
4
Place the bobbin on the bobbin winder shaft
so that the spring on the shaft fits into the
notch in the bobbin.
1 Notch
2 Bobbin winder shaft spring
● Only use the bobbin (part code: SA156, XA5539-151) designed specifically for this sewing
machine. Use of any other bobbin may result in injuries or damage to the machine.
● The enclosed bobbin was designed specifically for this sewing machine. If bobbins from older
models are used, the machine will not operate correctly. Use only the enclosed bobbin or
bobbins of the same type (part code: SA156, XA5539-151).
CAUTION
Actual size
This model Older model
11.5 mm
(7/16 inch)
1
1
2
S2_brotherE.book Page 12 Thursday, February 13, 2003 11:03 AM