Brother DCP-8110DN - Manual (Page 64)

54
DIMM Error
 The DIMM is not installed
correctly.
 The DIMM is broken.
 The DIMM does not meet
the required specifications.
 Turn off the machine and remove the
DIMM.
(See Advanced User's Guide: Installing
extra memory.)
 Confirm the DIMM meets the required
specifications.
(See Advanced User's Guide: Memory
board.)
 Re-install the DIMM correctly. Wait a few
seconds, and then turn it on again.
 If this error message appears again,
replace the DIMM with a new one.
(See Advanced User's Guide: Installing
extra memory.)
Document Jam
The document was not
inserted or fed correctly, or the
document scanned from the
ADF was too long. See Document is jammed in the top of the ADF
unit uu page 59 or Using the automatic
document feeder (ADF) uu page 23.
Drum Error
The corona wire on the drum
unit needs to be cleaned. Clean the corona wire on the drum unit.
(See Cleaning the corona wire uu page 45.)
The toner cartridge is placed in
the machine without the drum
unit. Put the toner cartridge into the drum unit, and
then re-install the drum unit and toner cartridge
assembly in the machine.
Drum Stop
It is time to replace the drum
unit. Replace the drum unit.
(See Replacing the drum unit uu page 48.)
Duplex Disabled
The back of the machine is not
closed completely. Close the back cover of the machine.
Fuser Error
The temperature of the fuser
unit does not rise to a specified
temperature within the
specified time. Turn the power switch off, wait a few seconds,
and then turn it on again. Leave the machine
for 15 minutes with the power on.
The fuser unit is too hot.
Jam Duplex
The paper is jammed in the
duplex tray or the fuser unit. See Paper is jammed in the duplex tray
uu
page 70.
Jam Inside
The paper is jammed inside the
machine. See Paper is jammed inside the machine
uu
page 66.
The toner cartridge is placed in
the machine without the drum
unit. Put the toner cartridge into the drum unit, and
then re-install the drum unit and toner cartridge
assembly in the machine.
Jam MP Tray
The paper is jammed in the MP
tray of the machine. See Paper is jammed in the MP tray
uu
page 61.
Jam Rear
The paper is jammed in the
back of the machine. See Paper is jammed at the back of the
machine uu page 63.
Error Message Cause Action