Brother QL-570 - Manual (Page 16)

STEP1 Getting started 10
2
Put the spool into the spool guides in the DK
Roll compartment.
•
Make sure that the spool arms are inserted firmly in
the spool guides on the left and right.
•
Insert the spool with the DK Roll located on the right
hand side of the Brother QL-570/580N.
3
Thread the end of the DK Roll into
the slot until it align to the area
shown right.
Align the end of the roll with the upright
edge of the label output slot.
4
Close the DK Roll compartment cover.
When you press the ON/OFF button ( ) to turn the
Brother QL-570/580N on, the end of the DK Die-cut
Label is aligned automatically.