Brother Innov-i - Manual (Page 143)

Troubleshooting 141
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
4
Bobbin thread does
not wind neatly on
the bobbin.
The thread is not passed through the
bobbin-winding thread guide
correctly.
Correctly pass the thread through
the bobbin-winding thread guide.
page 22
Bobbin spins slowly.
Move the sewing speed controller
to the right (so that the speed will
be fast).
page 25
The thread that was pulled out was
not wound onto the bobbin
correctly. Wind the thread that was pulled
off round the bobbin five or six
times clockwise.
page 24
Fabric being sewn
with the machine
cannot be removed.
Thread is tangled below the needle
plate.
Lift up the fabric and cut the
threads below it, and clean the
race.
page 132
The fabric feeds in
the opposite
direction.
The feed mechanism is damaged.
Contact your dealer or the nearest
authorized service center.
–
The upper thread
has tightened up. The bobbin thread is incorrectly
installed. Correctly install the bobbin
thread. page 26,
128
The thread is
tangled on the
wrong side of the
fabric.
You have not threaded the upper
thread properly.
Correct the upper threading.
page 28,
129
Symptom Probable Cause Remedy Reference