Brother PE-DESIGN 8 - Manual (Page 8)

6
Before Use
[STEP1] Installing the Software
This section describes how to install the application software.
1.
Insert the enclosed CD-ROM into the computer's CD-ROM drive.
■
For Windows
®
XP or Windows
®
2000 users:
→
After a short while, the Choose Setup Language dialog box automatically appears.
Continue with step
3.
on page 8.
a
Note:
• If the installation is interrupted or not performed as described, the software will not be installed
correctly.
• Before turning on the computer, be sure that the USB card writer module is DISCONNECTED.
• In order to install the software, you must log on to the computer using an account with administrator
privileges. If you are not logged on with the Administrator account, the password for the
Administrator account (Administrators) may be requested with Windows Vista
®
. Type in the
password to continue the procedure.
b
Memo:
If the installer does not automatically start up:
1) Click the Start button.
2) Click Run.
→
The Run dialog box appears.
3) Type in the full path to the installer, and then click OK to start up the installer.
For example: D:\setup.exe (where "D:" is the name of the CD-ROM drive)