Brother MFC-5895CW - Manual (Page 29)

29
For Wireless Network Users
Wirele
ss Network
17
Confirm your network environment (Infrastructure Mode)
The following instructions will offer two methods for installing your Brother machine in a wireless network
environment. Both methods are for infrastructure mode, using a wireless access point/router that uses DHCP to
assign IP addresses. Choose a configuration method and proceed to the page indicated.
a
If your wireless access point/router does not support Wi-Fi Protected Setup™ or AOSS™, write
down the wireless network settings of your wireless access point/router in the area below.
IMPORTANT
If you do not know this information (Network Name (SSID/ESSID), and Password), you cannot
continue the wireless setup. You should see the documentation provided with your wireless
access point/router, consult the router manufacturer, or your system administrator.
Item Record the current wireless network settings
Network Name: (SSID/ESSID)
Password
Your Brother machine supports the use of the first WEP KEY only. If you are using a router that is using
more than one WEP KEY enter the KEY used for the first WEP KEY.
Now go to
page 30
b
If your wireless access point/router supports automatic wireless (one-push) setup (Wi-Fi Protected
Setup™ or AOSS™)
Now go to
page 32