Brother HL 5370DW - Manual (Page 31)

31
Windows
® Wireless Network
Windows
®
Macintosh
Wireless Network
l
Put your access point in the
SecureEasySetup™ mode, the Wi-Fi
Protected Setup mode or the AOSS™ mode,
depending on what is supported by your
access point. Please refer to the instruction
manual that came with your access point.
m
Wait until the Status LED of your printer
indicates Connected. The Status LED will
turn on for 5 minutes. (See LED indications
when using the one-push wireless setting
mode on page 53) This indication means the
printer has successfully connected to your
access point/router. You can now use your
printer with your wireless network.
If the LED indicates Connection Fail (See
LED indications when using the one-push
wireless setting mode on page 53), the printer
has not successfully connected to your access
point/router. Try starting from
j on page 30
again. If the same message is indicated again,
reset the print server back to its factory default
settings. For resetting, see Reset the network
settings to the factory default on page 43.
If the LED indicates No Access Point (See
LED indications when using the one-push
wireless setting mode on page 53), the printer
has not detected a access point/router on your
network. Make sure you place the printer as
close to the network access point/router as
possible with minimal obstructions, and try
starting from
j on page 30 again. If the same
message is indicated again, reset the print
server back to its factory default settings and
try again. For resetting, see Reset the network
settings to the factory default on page 43.
If the LED indicates Connection Error (See
LED indications when using the one-push
wireless setting mode on page 53), the printer
has detected more than 2 access
points/routers on your network that have the
SecureEasySetup™, the Wi-Fi Protected
Setup mode or the AOSS™ mode enabled.
Make sure that only one router or access point
has the SecureEasySetup™ mode, Wi-Fi
Protected Setup mode or the AOSS™ mode
enabled and try starting from
j on page 30
again.
n
Click Next.
o
Check the box after you confirm that you have
completed the wireless settings, and then click
Next.
Install the printer driver
p
When the License Agreement window
appears, click Yes if you agree to the License
Agreement.
IMPORTANT
• DO NOT try to cancel any of the screens
during this installation.
• If your wireless settings fail, an error
message will appear during the installation
of the printer driver and the installation will
be terminated. If you encounter this failure,
reset the print server back to its default
factory setting (see page 43), and please go
back to step
e on page 30 and setup the
wireless connection again.