For wireless network users, Recommended), For windows – Brother HL 5370DW User Manual

Page 23

For Wireless Network Users

Wireless Network

Windows

Macintosh

Confirm your network environment (Infrastructure Mode)

Choose a configuration method and proceed to the page indicated.

Configuration using the Brother installer application on the CD-ROM

(Recommended)

Configuration temporarily using a network cable
You need to temporarily use an Ethernet cable when you configure your Brother printer with this
method. The Ethernet cable is not a standard accessory.

If there is an Ethernet Hub or Router in the same network as the wireless access point

, you can temporarily connect

the Hub or Router to the printer using an Ethernet cable

. This is an easy way to configure the printer. You can then

remotely configure the printer from a computer on the network.

Now go to

For Windows

Users go to page 24

For Macintosh Users go to page 33

Configuration using the automatic wireless (one-push) method

If your wireless access point

supports either SecureEasySetup™, Wi-Fi Protected Setup (PBC

) or AOSS™, you can

configure the printer without knowing your wireless network settings. The access point /router and your printer can
automatically negotiate using the SecureEasySetup™, Wi-Fi Protected Setup or AOSS™ procedure.

Push Button Configuration

Configuration using the PIN Method of Wi-Fi Protected Setup

If your wireless access point

supports Wi-Fi Protected Setup, you can also configure using the PIN Method of

Wi-Fi Protected Setup. For instructions, see Chapter 7 in the Network User’s Guide on the CD-ROM.

Now go to

For Windows

Users go to page 29

For Macintosh Users go to page 38