Brother QL-500 - Manual (Page 25)

25
If glue accumulates on the label outlet
and the machine becomes jammed,
disconnect the power plug from the
electrical outlet and clean the label
outlet with a cloth dipped in isopropyl
alcohol.
It is recommended to clean the label
outlet when replacing the cutter unit.
4
Insert the edge of cleaning sheet into the slot until it is just in
front of the cutter.
• Insert the sheet without removing the part of sheet.
• Check that the printing surface of cleaning sheet is facing upward.
5
After inserting the cleaning sheet into the slot,
push down the roll release lever and remove
the part of cleaning sheet.
6
Close the DK Roll cover and turn ON the power.
7
Press the Feed button for more than one
second.
The roller spins by 4" (10 cm).
The adhesive face of cleaning sheet removes the stain
or dust on the roller.
• If not pressing the Feed button for more than one
second, the roller spins only 1/3" (8 mm).
• Dispose the cleaning sheet after use.
A
A
B
Feed button
Label outlet maintenance
Label outlet