Brother QL-500 - Manual (Page 16)

Before using the printer 16
1
Check that the power is turned OFF (check
LED lamp).
Lift up the DK Roll cover by the tabs at the
sides of the cover.
2
Pull up the roll release lever and
remove the protective sheet of
printing unit.
3
Insert the spool of the DK Roll
along the spool guide of the
printer.
Check the both sides of spool of DK
Roll are correctly inserted into
spool guide of the printer.
4
Check that the roll release lever
is in the up position.
Insert the edge of DK Roll into
the slot until it is just in front of
the cutter.
2 Installing the DK Roll
Roll release lever
Printing unit protective sheet
Spool
Spool guide
Roll release lever
Printing unit
Cutter