Brother Fax 1360 - Manual (Page 27)

General setup
13
3
Speaker Volume
3
You can choose a range of speaker volume
levels, from High to Off.
a
Press Menu, 1, 3, 3.
b
Press a or b to choose Low, Med,
High or Off.
Press OK.
c
Press Stop/Exit.
You can also adjust the speaker volume by
pressing Hook/Hold.
a
Press Hook/Hold.
b
Press d or c .
This setting will stay until you change it
again.
c
Press Hook/Hold.
Handset Volume
3
a
Press Menu, 1, 3, 4.
b
Press a or b to choose Low or High.
Press OK.
c
Press Stop/Exit.
Note
• You can adjust the handset volume any
time you are talking on the telephone.
There are two handset volume levels, Low
and High. The default setting is Low.
• Press d or c to adjust the volume
level. The LCD shows the setting you are
choosing. The new setting will remain until
you change it again.
Choosing the Handset
Volume (For Volume Amplify)
3
Before you begin to use the machine, you
must decide if you need to set the handset
volume to Vol Amplify:On for a user who
is hearing-impaired. The AMPLIFY volume
level complies with FCC standards.
Vol Amplify:Off
This default setting is appropriate if none of
the users are hearing-impaired. During a
conversation, users can press
d or c
on the control panel to adjust the volume to
Low or High. When the handset is replaced,
the handset volume will remain until you
change it again.
Vol Amplify:On - Temporary
This setting is appropriate if some of the
users are hearing-impaired. During a
conversation, users can press
d or c
on the control panel to adjust the volume to
Low, High or Volume Amplify. When the
handset is replaced, the handset volume
returns to the default setting of Low.
Vol Amplify:On - Permanent
Choose Vol Amplify:On—Permanent if
all of the users are hearing-impaired. During
a conversation, users can press
d or c
on the control panel to adjust the volume to
Low, High or Volume Amplify. When the
handset is replaced, the handset volume
returns to the default setting of
Volume Amplify.
Note
When you press d or c on the control
panel to adjust the volume, the LCD shows
the setting you are choosing. Each key press
changes the volume to the next setting.
WARNING
It is important that you do NOT choose
Permanent unless ALL the users are
hearing-impaired. Otherwise, the default
setting of Volume Amplify may damage
the hearing of some users.