Brother NX-800 - Manual (Page 43)

Replacing the Presser Foot 41
1
—— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Replacing the Presser Foot
The presser foot presses down on the fabric.
Presser foot precautions
Be sure to observe the following precautions
concerning the presser feet.
CAUTION
Replacing the presser foot
Replace the presser foot as described below.
For details on using the side cutter “S”, refer to
“Sewing overcasting stitches using the side cutter”
(page 78).
a
Press (“Needle Position” button) once or
twice to raise the needle.
a “Needle Position” button
X The needle is raised.
b
Turn off the sewing machine.
CAUTION
c
Raise the presser foot lever.
a Presser foot lever
X The presser foot is raised.
● Use the presser foot appropriate for the
type of stitch that you wish to sew,
otherwise the needle may hit the presser
foot, causing the needle to bend or break.
● Only use presser feet designed specifically
for this sewing machine. Use of any other
presser foot may result in injuries or
damage to the machine.
● Before replacing the presser foot, be sure
to turn off the sewing machine, otherwise
injuries may occur if
(“Start/Stop”
button) is accidentally pressed and the
machine starts sewing.
1
a