Brother NX-200 - Manual (Page 6)

Cover E
Operation panel
The operation panel, located on the front at the right of the sewing machine, consists of various buttons and
sliders for specifying how the stitch will be sewn.
1 Stitch width adjustment slider / 2 Stitch width adjustment button
These are used to adjust the width of the stitch or the needle position. After pressing the stitch width adjustment button, use
the stitch width adjustment slider to adjust the stitch width.
3 Stitch length adjustment slider / 4 Stitch length adjustment button
These are used to adjust the length of the stitch. After pressing the stitch length adjustment button, use the stitch length
adjustment slider to adjust the stitch length.
5 Automatic reverse/reinforcement stitch key
Press the automatic reverse/reinforcement stitch key to automatically sew reverse or reinforcement stitches at the
beginning and end of stitching.
6 Needle stop position key
This is used to change the position of the needle when the sewing machine is stopped. If the key is lit, the sewing machine
will stop with the needle lowered. If the key is not lit, the sewing machine will stop with the needle raised.
7 Stitch selection key / 8Stitch indicator
Press the stitch selection key, and then select the number for the stitch that you wish to use. 50 stitches are available. For
details, refer to “Selecting Stitching” (page 54).
9 Stitches
There are 50 stitches. Select stitch 00-49.
A letter (A, G, J, N or R) indicating the presser foot that should be used appears to the right of the stitch number.
1 2
3
4
5
6 7
8