Anchor Industries NAV50-1204 - Manual (Page 2)

Index
TABLE OF CONTENTS
Page No. Assembly Step
2 Squaring Footprint and Laying out Uprights
3 50’ NAVI-TRAC component list and Hardware Location Chart
4 Introduction
5 50’ NAVI-TRAC Component Illustrations
6 NAVI-TRAC Installation Safety Guidelines
7 Construct End Module Top Frame
9 Install Hip End Fabric
10 Installing Uprights Under the Top Frame
11 Tensioning and Guying Fabric
12 Constructing Hips for Rectangular Tents
13 Constructing Middle Bay Frame
14. Installing Mid Panels
15 Units with (2) or more Mid Bays and X-Cabling Requirements
16 50’ NAVI-TRAC Complete
16 FASTENING HARDWARE, GRAVITY PINS, LANYARD PINS & BOLTS
ILLUSTRATIONS:
2-T SQUARING FOOTPRINT
2-B POSITIONING UPRIGHTS
3-T NAVI-TRAC COMPONENT LIST
3-B FASTENING HARDWARE, GRAVITY PINS, LANYARD PINS & BOLTS
4-T 50’ NAVI-TRAC FRAME TERMINOLOGY
4-B SQUARE TENT TOP FRAME
5-T 50’ NAVI-TRAC COMPONENT ILLUSTRATIONS
7-T LAYOUT END MODULE COMPONENTS
7-B CONSTRUCT FIRST BEAM
8-T ASSEMBLING HIP END TOP FRAME
8-B COMPLETING HIP END TOP FRAME
9-T SQUARE UNIT TOP FRAME COMPLETE
10-T LIFTING TOP FRAME (FIRST SIDE)
10-B LIFT TOP FRAME (SECOND SIDE)
11-T TENSIONING AND GUYING
12-T HIP END MODULES FOR RECTANGULAR UNITS
12-B COMPLETING THE HIP END
13-T UNITS WITH (1) MIDDLE BAY
13-B INSTALLING MID BAY PURLINS AND EAVE/ RIDGE BARS
14-T PURLIN SUPPORTS IN 20’ MID BAYS
14-B INSTALLING MID PANELS
15-T UNITS WITH (2) OR MORE MID BAYS
15-B X-CABLED BAYS
16-T 50’ NAVI-TRAC COMPLETE WITH FABRIC AND GUYING