Brother PR-620 620C 600II 600IIC - Manual (Page 15)

13
ENGLISH
c Remove the two upper thumb screws.
1
Thumb screws
d Remove the cylinder frame driver.
Note
● Be careful that the cylinder frame driver
does not hit any nearby parts, such as the
presser foot and other machine parts.
e Align the hole in the L-shaped mounting
bracket for the cylinder frame driver with
the centerline of the guiding plate, insert the
two thumb screws removed in step
c
into
the holes at the top, and then tighten the
thumb screws.
1
Hole in L-shaped mounting bracket
2
Centerline of guiding plate
3
Hole at the top
• Insert the thumb screws into the holes where
the cylinder frame driver was originally
installed (holes that the thumb screws were
removed from in step
c
).
X The movable section of the cylinder frame
driver is secured.
f Align the holes in the embroidery frame
holder with the pins on the X carriage, and
then secure the embroidery frame holder
with the two thumb screws.
1
Pins on the X carriage
2
Holes in the embroidery frame holder
1
a
b
c
a
b