Ultra Start 600 - Manual (Page 11)

Installation Guide
When activated, the system waits 30 seconds then flashes LED rapidly for 30 seconds, then chirps
the siren as a warning for 10 seconds then goes into full alarm .
Program Menu 2, Setting 5
- Mode 1 & 2 While ignition is “ON” press and release the # button.
- Mode 1 & 2 The door is opened while the ignition is “ON”.
- Mode 2 only Each time ignition is turned “ON”
1. During the countdown period - Turn ignition “ON” then press and release the Program Button.
2. After full alarm - Turn ignition “Off” then “ON”” then press and hold the Program Button for
Eight seconds.
OTHER FEATURES
11
ACTIVATING SERVICE MODE
1. While the ignition is “ON” press and hold the Program Button for five seconds. The
park lights will flash and the siren will chirp five times to confirm that the system is in
Service Mode.
2. While in Service Mode the remote start functions will be disabled and LED’s will be
“ON” steady. Door locks and trunk release are still operational.
DEACTIVATING SERVICE MODE
1. While the ignition is “ON” press and hold the Program Button for five seconds. The
park lights will flash and the siren will chirp two times to confirm that the system has
exited Service Mode.
2. Remote start functions will return to normal operation.
System Service Mode
Service Mode- By Remote
SERVICE MODE ACTIVATED
1 - Press & Release button 4
2 - Press & Hold Button 4 for 6 seconds until Status LED comes on Steady
NOTE: The siren will chirp 5 times as confirmation.
SERVICE MODE DEACTIVATED
1 - Press & Release button 4
2 - Press & Hold Button 4 for 6 seconds until Status LED turns off.
NOTE: The siren will chirp 2 times as confirmation.
Anti Car Jacking Mode
ACTIVATING CAR JACK MODE
DEACTIVATING CAR JACK MODE
**************ENSURE THAT USER IS FULLY TRAINED ON THIS FEATURE!***************
ONLY PROGRAM THIS FEATURE WHEN SPECIFICALLY REQUESTED. ENSURE THAT USER IS
FULLY TRAINED ON THE OPERATION OF THIS FEATURE. IF THE USER IS NOT TRAINED ON
THE USE OF THIS FEATURE, UNWANTED RESULTS MAY ARISE.