Transmitter operations – Ultra Start 600 User Manual

Page 10

Installation Guide

TRANSMITTER OPERATIONS

See Owner’s Guide for More Detail on Operations

Press Once to Lock the doors and arm the alarm. Hold for Panic Mode.
Press a second time and hold for Constant Lock Output.

Press once to unlock the doors and disarm the alarm
Press and hold for the Trunk / Aux Output

Press this button to activate the 4th channel output.
This output can be used to activate additional alarm features.

Press once and hold for Car Finder
Press and release then hold to activate/deactivate Service Mode.

Second Car Operation

First Car Operation

First Car

2nd Car

=
=
=

then

Step 1 - Within three seconds turn the ignition Key ON-OFF-ON-OFF-ON - Leaving Key ON
Step 2 - Press and hold the Program Switch - Parking Lights will come ON **if park-lights do not come on

at this point, turn key off for 5 seconds, then repeat step 1.

Step 3 - Continue to hold the Program Switch until park lights go out.
Step 4 - Press the LOCK button on each of 1st car remote’s and press the # button on each of the 2nd

car remote’s of the transmitters to be programmed. The park lights will flash once and the siren
will chirp once each time a new code is learned.

Note: Transmitter programming must done quickly. Do not pause more than one second between each
transmitter. All the transmitters to be used must be programmed at the same time. All transmitters
not programmed at this time will be erased from memory for security. The system holds a
maximum of 3 transmitter codes including 2nd car remote codes.

You can program the same remote as a 1st car remote in one vehicle and as a 2nd car remote in a
second vehicle.

Step #1 Step #2

Step #3 Step #4

Carefully remove the

screw from back of

the remote.

Remove top case

then replace the

battery.

Replace top case.

Re-install screw.

Test remote for

proper operation.

The transmitter battery should be changed at least once every year to maintain proper operating range.

Replace with quality23A 12volt Alkaline battery.

Transmitter Programming

Battery Replacement