Trio Motion Technology MC405 - Manual (Page 2)

This is a 5 way 3.5mm pitch connector. The
connector is used both to provide the 24 Volt
power to the MC405 and provide connections
for I/O expansion via Trio’s CAN I/O expanders.
A 24V dc, Class 2 transformer or power source
must be provided as this powers the unit.
This 24 Volt input is internally isolated from the
I/O 24 Volts and the +/-10V voltage outputs.
The 24V (V+) and 0V (V-) MUST be connected
as they power the MC405. The MC405 is
grounded via the metal chassis. A screw is
provided on the chassis at the rear to allow
an earth strap connection if needed. It MUST
be installed on an unpainted metal plate or
DIN rail which is connected to earth. The CAN
connections are optional.
5-WAY
CONNECTOR
V+ SHIELDCAN
-L
CAN
-H
V-
A standard Ethernet connector is provided for use as
the primary programming interface.
The Trio programming software, Motion Perfect, must
be installed on a Windows based PC that is fi tted with
an Ethernet connection. The IP address is displayed on
the MC405 display for a few seconds after power-up or
when an Ethernet cable is plugged in.
Ethernet cable must be CAT 5 or better.
RJ45
CONNECTOR