Timeguard TPT44 - Manual (Page 7)

6
Program Setting
Example:
If you want to set 2 different programs,
i.e. ON at 6am and OFF at 9.30am and then
in the evening ON at 17.30 and OFF at 22.30.
1. Press the ‘Prog’ button once and the time will
start to flash. (In the Programming mode you will
see a ‘ ’ on the top right hand side of the display,
if there is no activity within 15 seconds the unit
will exit the Programming mode and will start
to run in the Normal Operating Mode).
2. Press the ‘Set’ button once. The time now will
show ‘0:00’ flashing and the Time-Zone indicator
at the 24 hour mark. (You will need to make
sure that at this point none of the segments
are highlighted. If there are segments visible,
press the ‘–’ button until all have disappeared
and you are back around to the 24 hour mark).
3. You will now be in the Set Back mode with the ‘ ’
symbol showing on the display. Using the ‘+’ button
advance to 6am and press the ‘Prog’ button once.
4. You will now be in the Comfort mode with the ‘ ’
symbol showing on the display. Again using the ‘+’
button highlight the segments on the Time-Zone
indicator until you reach the OFF time (9.30am).
5. Press ‘Prog’ to change the mode back to Set Back
with the ‘ ’ symbol showing. Using the ‘+’ button
advance to the next ON time. In this case at 17.30.
6. Press ‘Prog’ to change the mode back to Comfort
with the ‘ ’symbol showing. Using the ‘+’ button
advance to the next OFF time. In this case 22.30.