Timeguard 200.0.000 - Manual (Page 7)

4
3.3 Connection
The presence detector must be flush
mounted into a concealed housing. The
enclosed set of seals is to be used for
IP54 installation.
A suitable frame for surface mounting is
also available. If the surface-mounting
seal set is used for surface mounting, the
detector will also comply with Protection
Class IP54.
3.4 Protection Class IP4
To ensure compliance with Protection
Class IP54 when flush mounted, the pre-
sence detector must be installed using the
enclosed IP54 seal set for flush mounting
as shown in the figure alongside.
If the seal set is not used, only Protection
Class IP40 will be achieved.
PresenceLight
N
L
N L
A
IP54 mounting with gas-
ket set IP54 only!

GB