Timeguard 200.0.000 - Manual (Page 12)

2
6. Test mode
The test mode serves to check the presence detection and the wiring.
6.1 Setting the test mode with potentiometer
Set potentiometer «min.» to «test».
1. Start-up phase (30sec)
The switching contact is closed for 30sec. ( LED 20s «on», 10s «off» ).
2. Test mode
In case of movement (LED on), the contact closes.
In case of absence (LED off), contact opens after 10sec.
The detectors remain permanently in the test mode.
6.2 Setting the test mode with QuickSet plus
While setting the test mode with the service remote control QuickSet plus,
the detector jumps the startup phase and changes directly into test mode.
Test mode ceases automatically after 10 minutes.The detector performs
a reset (see section 4.3).
●
●
●
●
●
●
●
Please note: brightness measurement inactive in test mode.
