Timeguard DSS - Manual (Page 12)

11 12
Delay time
adjuster.
Time range
selector
Fig 2 – Rear of DS2
2. Installation.
IF IN DOUBT CONSULT AN ELECTRICIAN.
SWITCH OFF MAINS ELECTRICITY.
Set the switch position to 1 ON, 2 OFF and the delay time adjuster
to minimum (fully anti-clockwise – see fig 2) to enable initial testing
during commissioning.
Connect the three wires to the appropriate terminals.
Mains Live – L
Switch Live – SL (to load)
Neutral – N
If two wires were connected to any terminal on the original switch
they must be kept together and connected to the appropriate
terminal on the DS2.