Timeguard ZV700 - Manual (Page 8)

7 8
Zer
ofour – October 2013
Setting clock
Programme 1 ON
Programme 1 OFF
Programme 2 ON
Programme 2 OFF
Programme 3 ON
Programme 3 OFF
Programme 4 ON
Programme 4 OFF
Programme 5 ON
Programme 5 OFF
Programme 6 ON
Programme 6 OFF
Operation Mode
Programming sequence
Note: Pauses between button presses greater than 1 minute during
programming will result in automatic return to the operating mode.
10. Setting Clock (after reset)
i Day Setting – Press button to advance to the day required.
Day 1 = Monday and Day 7 = Sunday.
ii Hour Setting – Press the button briefly
to select the hours – display shows clock symbol and
the hours digits flashing.
Press the button to advance the hour
setting. For rapid hours selection press and hold down
button. (Note: Monday shown as example
of day set.)
iii Minute Setting – Press the button briefly
to select the minutes – display shows clock symbol and
minute digits flashing. Press the button
to advance the minutes setting. For rapid minute
selection press and hold down button.
(Note: 16 hours shown as example of hours set)
iv Press button briefly – clock is now
set and display shows ready for the first ON
programme time.