Sterlco SPS Series Pipe Shredder - Manual (Page 16)

GRN4-610 Chapter 2: Functional Description 16 of 73
Control
The pusher feeds the rotor with as much material as it is able to process. Upon reaching
70-90 % of rated current, the feeding of the pusher will be stopped and automatically
started again after the power consumption has fallen by 20 % in comparison with rated
current. If the high current is applied for longer than 0.7 - 1.5 sec., the main drive motor
switches off and runs back after about 3 sec. standstill time. The pusher plate also runs
back whilst the rotor runs back. The drive motor then stops for another 3 sec. before
starting again. The position of the pusher is controlled by an optical distance sensor. The
in feed is controlled according to load. Duration of pauses and return as well as the
current settings can be adjusted. Any alterations, however, should only be carried out
after consulting the manufacturer.
Grinding Material In-feed
The grinding material can be fed into the shredder using the following methods:
•
Manual in-feed of the grinding material directly into the feeding trough.
• Manual in-feed of the grinding material with the help of an additional in-feed
device (i.e. hydraulic feeding unit).
In-feed Hopper
The grinding material in-feed ensues via a feeding trough. The pipe can be placed easily
in the feeding trough by a forklift.
Illustration:
Feeding trough
The feeding trough has a hydraulically operated cover, which is
closed after it is filled with material.
A hydraulic ram system is than pushing the material towards the rotor.