Sterlco GH-M Series Extrusion Control Weigh Hoppers - Manual (Page 18)

Chapter 2: Functional Description 18 of 60
After installation and setup, the GH-M will begin monitoring the system process once the rate
monitor detects an extruder speed.
The following figures show some typical screens of the GH-M rate monitor.
Figure 8: Typical GH Series Controller Touch Screen Display
Figure 9: Controller Pushbuttons & Touchscreen Tags
Button
Function
(Power On)
Turns power on to the GH Hopper controller.
(Found on the back of the controller.)
(Power Off)
Turns power off to the GH Hopper controller.
(Found on the back of the controller.)
Stops GH Hopper & restarts controller.
Press to move back one screen level in
controller function.
Move forward one screen level in controller
function.