Milestone Analytics 2.2 BOSCH VCA - Manual (Page 25)

Milestone XProtect Analytics 2.2 – BOSCH VCA; Administrator’s Manual
www.milestonesys.com Page 25 BOSCH VCA Administrator
Changing Licenses (SLC/CLK)
Your licences determine how you are able to use XProtect Analytics:
 Your Software License Code (SLC) determines your right to use a full version of the
software. The SLC is a 13-character long combination of digits, letters and dashes
(example: AB1-2345-CD67).
 Your Connection License Key (CLK) determines how many cameras you are allowed to use
with XProtect Analytics, and thus how many so-called connections you are able to
establish. The CLK is a 16-character long combination of digits and letters (example:
12abc34d56e78f90).
You specify the SLC and DLK during installation of XProtect Analytics, unless you install a trial
version (for which licenses are not required). Sometimes it is necessary to change the licenses, for
example if:
 You want to upgrade a trial version to a full version. In that case you acquire a
Software License Key (SLC) and a Connection License Key (CLK) from your Milestone
vendor, and specify them in the XProtect Analytics Administrator application. See the
following for more information.
 You want to extend the number of cameras you are allowed to use with XProtect
Analytics. In that case you acquire a new Connection License Key (CLK) from your
Milestone vendor, and overwrite the old one. See page 25 for more information.
Specifying SLC and CLK to Upgrade
1. In the Administrator application, expand the License management folder.
2. Click the blue Trial Version -
# day(s) left text to access
the License management
features:
Tip: Note the MAC address
for this machine field. The
field lists the MAC (Media
Access Control) address of the computer on which XProtect Analytics is installed. The MAC
address uniquely identifies the computer. If you later need to get a new license—for
example if you need to use more cameras than covered by your original license—your
Milestone vendor is likely to ask you for the MAC address.
3. In the Software License Code (SLC) field, specify your SLC. Then click the Set button.
4. In the Connection License Key (CLK) field, specify your CLK. Then click the Set button.
5. Save your new settings by clicking the Save button in the Administrator
application’s toolbar.
Note that when certain settings have changed, the Server
service must be restarted. To verify whether this is required,
look at the server service status indicator in the bottom right
corner of the Administrator application. In case restart is required, click the
Restart Server button in the Administrator application’s toolbar.