Innotech Device Communications - Manual (Page 36)

© MASS ELECTRONICS Pty Ltd 2011
DS 99.05 – Ethernet Setup Manual for Device Communications
Page 28
Edition 1.0 dated 04/10/11
4
Click on the 4. Communication tab to modify the Ethernet settings of IWS01 to suit your
LAN requirements, as illustrated in Figure 4-28 below.
IWS01 – Click on Communication tab Figure 4-28:
Configure IWS01 Ethernet settings Figure 4-29:
Enter the necessary information to configure the Ethernet settings of IWS01 according 5.
to your LAN requirements, as illustrated in Figure 4-29 below. When you have
finished entering all of the necessary information, click on Apply Changes to save the
new settings.
Enter IP address
Enter network mask
Enter default
gateway router IP
address
NOTE
If you modify the default Ethernet settings, remember to change your computer network settings
accordingly. Refer to the Configuring network settings of your computer section for instructions.