Dwyer WTDL-RX - Manual (Page 5)

WTDL-RX
3
The default wireless channel for Dwyer wireless devices is channel 11. Different
wireless channels may be used to create multiple networks in one area, or to
avoid wireless interference from other devices. The diagram below show the
orientations available of the switches for each channel. Channel 26 (all switches
in the up position) is not supported.
Channel 11 Channel 12 Channel 13 Channel 14
Channel 15 Channel 16 Channel 17 Channel 18
Channel 19 Channel 20 Channel 21 Channel 22
Channel 23 Channel 24 Channel 25 Channel 26
(not supported)
Follow the instructions below to configure the channel settings for Dwyer WTDL
Data Loggers.
WTDL-RX: To program the channel on an WTDL-RX, first unplug the WTDL-RX.
Use a Phillips head screwdriver to unscrew the enclosure. The dip switches are
located on the front of the PCB circuit board. Change the dip switches to match
the desired channel settings by referring to the diagram above. Reconnect the
WTDL-RX.