Dwyer WTDL-RX - Manual (Page 4)

Product User Guide
2
WTDL Series: Switch the wireless ON / OFF switch to ‘0’. The dip switches
are located on the back of the device. Switch the wireless ON / OFF switch
back to ‘1’.
Deploying and Activating Devices
Step 1: Plug the WTDL-RX into the USB port on the base station computer.
(Additional WTDL-RXs can be used as repeaters to transmit over greater distances)
Step 2: If using multiple WTDL-RXs plug each one into a wall outlet in the
desired locations. (If transmitting over a distance greater than 700 feet indoors or
2500 feet outdoors or there are walls/obstacles/corners that need to be maneuvered
around, set up additional WTDL-RXs as needed.)
Step 3: Verify that the data loggers are in wireless transmission mode. (See
Channel Programming steps above)
Step 4: On a Windows PC, launch the DL700 software program. All active data
loggers will be listed in the software showing that the device(s) are recognized.
Step 5: To activate the data loggers, click on one to highlight, then click
the Claim icon, and then click the Start button. Repeat this step to activate
additional listed data loggers.